|
| Info |
Message |
Peter Walker
Midlands,
United Kingdom
Posts: 81
Premier Member
Daytona T595 (97-98)
06 May 2008 17:26 |
Hi
Any body tried to fit renntec sports rack with seat cowl on t595, I presume if poss will have to cut/dremel bits out of side.
Any pointers or pics of completed job please
Thanks Peter
|
 |
Rec
Oakworth, West Yorks,
United Kingdom
Posts: 597
Premier Member
Daytona T595 (97-98)
06 May 2008 18:52 |
Yep fitted one recently to my T595 , I had a slight problem fitting mine, the seller sold me the rack without the fitting kit  , I didn't realise it was missing until I actually attempted to fit it (Renntec wanted £25.00 for the fitting kit, I may be daft but I ain't stupid  )
Luckily for me it already had the Triumph Grabrail fitted  , so after a bit of thinking about it I used that instead to mount the front supports.
Peter DO NOT CUT/DREMEL OUT ANYTHING it not required.
But I did make a couple of rubber strips to fit under the rack at the back. You will still get a slight gap on seat cowl.
I'll take a few shots of mine and post them
|
|
Rec
Oakworth, West Yorks,
United Kingdom
Posts: 597
Premier Member
Daytona T595 (97-98)
06 May 2008 19:16 |
[edited]:
Couple of images in my little album
|
|
Peter Walker
Midlands,
United Kingdom
Posts: 81
Premier Member
Daytona T595 (97-98)
06 May 2008 21:26 |
Rec thanks for pics very helpfull, must be some way of getting closer fitting cowl, I do not mind dremmel/cut out of very neat profiles, not sure have confidence to do it ! 1 slip and its very expensive..
Can triumph or renntec grab rail be fitted with cowl
Bottom line being that I need a set up so I can swop to seat pad with a grab rail or rack already in place so I can take pillion with minimal refitting of grabby hold of bits.
Has any one had same issue and how did you get around it, and before you say it no I do not intend to buy a sprint for time being
Thanks Peter
|
|
red baron
n\w london,
United Kingdom
Posts: 6,081
Premier Member
Daytona T595 (97-98)
06 May 2008 21:57 |
i have a rentec grab rail fitted with a hump - no cutting required
|
|
Tonto (part deux)
Over the Hedge,
United Kingdom
Posts: 6,410
Premier Member
Enthusiast
08 May 2008 09:41 |
Got my grab rail off ebay and that had no fitting kit
Remember when you fit the rack you will need longer screws in mech that locks the hump down
|
|
